Skip to main content

Defender 3000 Canix Setup Instructions

Natalie M.
  • Updated

Preparing Equipment

  1. Connect the SerialIO Adapter to the RS232 port on the back of the Scale Indicator unit.

  2. Power on the Defender 3000 indicator.

  3. Power on the charged Serial IO adapter by pressing the button on the front

  4. Plug it into the back of the indicator. (You should see a green light glowing on the adapter)

Warning! Do not press and hold the power button on the device for more than 1 second—this will reset it to factory settings.

Set Up the Scale

  1. Now that the scale is powered and the adapter is plugged into the indicator, enter the setup menu by holding down the Tare/Menu button.

  2. Use the Yes/No/Back keys to navigate through the menu. 

  3. Enable Stable Only

    Menu > Print > Stable Only > On

  4. Set Stable Only in auto print

    Menu > Print > Auto Print > Stable Only

  5. Turn on both Gross and Net

    Menu > Print > Content > Gross > On
    Menu > Print > Content > Net > On

  6. Disable Parts Counting

    Menu > Mode > Count > Off

  7. Verify Baud is 9600

    Menu > Print > Baud > 9600

  8. Open the Canix Mobile Application and select Connect To Scale in the left hand menu on the home screen (make sure bluetooth is enabled on your phone)

  9. Select the adapter in the list (should be at the top, same ID that’s printed on the side of the adapter).

You should now be able to use Auto-Harvest, and to read scale weights from everywhere else inside the Canix Mobile Application.

Note:
If you need additional assistance, we've included the Ohaus indicator Manual here: https://www.ohaus.ca/pdf/3000-Series-Indicators-Man.pdf



Related articles